If each pressure level has two mechanical pressure levels, based on the pressure at a certain position of the part, it should be a separate host pressure level bit40.
The specific testing method is to place the tested component at a pressure level and adjust the auxiliary pressure level at the upper and lower ends of the pressure. Mark the pressure level of the corresponding component with a marker pen.
As long as two pressure levels are required to compress the same part within the pressure level standard range, generally speaking, as long as the rated pressure of the part is uniform, it should be within the standard range.
If the pressure deviation is not significant, a 3bar direct test can be used to check the DC voltage. It can generally be divided into two categories. The compression position of the auxiliary pressure level 3bar is the same as that of the standard voltage circuit. An additional pressure level is added, with the compression position located at the same location as the main pressure foot and the main circuit. The auxiliary pressure level is higher than the main pressure foot and is connected to a DC voltage.
Suzhou Loho Electronic Technology Co., Ltd. specializes in airtightness detectors, airtightness detectors, leak detectors, airtightness leak detectors, airtightness testers and other equipment. They are widely used, have fast detection speed, and are suitable for sealing, waterproofing, airtightness, leakage and other fields. Welcome to inquire by phone: 189-1262-8676
Sales WeChat
Technical WeChat
189-1262-8676
No. 18-16 Qianzhu Road, Wuzhong District, Suzhou City
